Search the Community
Showing results for tags 'bruin 350'.
-
Soon to begin working on a 2002 (i believe) Bruin 350 i recently got back. Reportedly will shut-off while driving it, and blows a fuse (i have not gotten a battery, and begun diagnosis myself yet). Was told if they change fuse and it goes again for a while until it happens again. Figured it was worth asking here if anyone has had a similar experience, and determined the cause (worth a shot right?)? TIA.
-
I’m considering looking at this quad I feel like it’s cheap enough but this is what the ad says so I’m concerned it has bigger issues than being reported. 2005 Yamaha Bruin 350 4x4. Does not run, motor spins freely and wants to fire but won’t. Done messing with it. replaced timing chain and gearing. Had it running good last year but can’t get it running now. PROJECT. Needs wiring gone threw and new pull start. I was jumping it to get it running. Just installed new starter a month ago also. Shoot me and offer or trade. Want it gone $750 obo
-
Just wondering where would i start to look for problems on my 4 wheel drive? I can hear it engaging but wont go in 4 wheel drive and the light dosent come on. Thanks
-
2005 Yamaha Bruin 350 4x4 runs fine, shifts from N to D and N to R fine but when in D top speed is mabey 15 mph, almost seems as if its stuck in 1st? Ive read that top speed is somewhere around 45 mph so obviously something is wrong. Any ideas? Thanks for your reply in advance.
-
Another question...noted on 2005 350 yamaha bruin a number of vacumn tubes hanging and not connected to anything...bought the ATV used...is there anywhere out there that has a diagram of where these tubes are supposed to be connected to?...been on line and looking at the carb and air filter diagrams, they show the tubes but not where they should be connected to
-
2005 Yamaha 350 bruin ATV sat for two years...hard start so drained the gas tank...new gas...started hard even with choke...but once started would go through the country side...sat for a month...hard start so pulled tank and cleaned it out...starts easy and idles fine without the choke...but the minute i try and throttle up it dies...if i start it with the throttle held half open will start and run...goes back to an idle just fine...but dies if i throttle up at all...looking in the ventura of the carb it looks like there is something restricting 2/3 of the air intake...? possible ruptured diaphram?...time for a new carb?