Quantcast
Jump to content

Recommended Posts

Posted

Changed oil, removed and cleaned float, needle and seat, and carb, changed oil again, still, several gallons of gas seep I to crank case, any ideas please? Not very good at setting the float so I dread rebuilding the carb.

Posted

if you hold the carb upside down and level with the bowl off, measure the distance from the mating surface of the bowl to the top of the float, i think if you are at a half inch or less you should be good. there is a metal tab where the needle slides onto to the float to adjust if need be ...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Mhatayas
      What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker 

    • By Dumass
      My name says it all. I have a '03 Honda Sporttrax 400EX with a new aftermarket carb on it that seems to be having issues. I can start it but it idles really rough and when I give it throttle it just kills the engine. I have tried adjusting the idle screw but to no avail. I am in the San Diego Ca area. 
      Any advice will be greatly appreciated. I would also like to get an owners manual for the thing too but can't seem to find a downloadable one.
    • By Trent Finnessey
      So I’ve got a 2000 Honda 400ex absolutely love it!! I’ve had it for about a month, I ride with bruteforce 750’s, outlander 850’s and 1000 sxs’s and I was thinking of getting a trx450r carb and a full hmf exhaust. And probably doing the air box mod too, how much power would this give my 400? Just a little different or a big difference? Cuz if it’s not much of a different I’ll just stick with my dg slip on..... thanks!
    • By Arizona
      I recently bought a 87 TRX 250 not running of course, the owner had a brand new Key Switch on it.
      I think it is the wrong one or wrong wire colors as the colors dont match up with wiring diagram i downloaded for it. 
      anyone have a pic of their ign switch wires where they connect with the wire colors for that model? I ended up leaving the black/w stripe and
      green wire disconnected in order to hot wire it for other testing but would like to know as the colors dont match diagram. 


    • By Travis_Smith
      I have a 2002 Kawasaki Prairie KVF 400 and im trying to figure out the actual float height... i have read 17mm +- 2mm, seen 13mm and 23mm... what is happening is it will start right up, rev a little and all is fine, when it warms and you put a load on it bogs down and sputters. no i don't have a manual
×
×
  • Create New...