Quantcast
Jump to content

Recommended Posts

Posted

My "08" Arctic Cat 650 H1 runs (plows or runs a trail) great for the first 15 minutes. I can get all the power needed. It starts cutting out when it gets warm/hot. There is no heat error and plenty of antifreeze, new spark plug and air filter. Not sure where to go from here. New coil? Have the valves checked? I would take it to the shop, but the waiting list is 3 weeks and I need it to plow snow.

Any ideas???

Thanks

Porps

  • 3 weeks later...
Posted

Got the coil installed just in time for 15 degrees and snow. The bike ran fine for quite a while.

BUT, starting cutting out again. It might have run longer because it was 15 degrees instead of 30 something. The snow was also much lighter. Either way.....I am chasing this problem with money!!!!! Could the belt cause this?

Posted

i always ran a hotter plug in my hondas thru the winter, it helped with starting and stalling after it was warmed up in the colder weather. i just had to remember to change it back once the warmer weather came. if you are running ngk, go down 1 number for the hotter plug. a spark plug isnt a whole lot of cash to put out ...

Posted

I don't mind trying that, but it was cutting out in the late summer too. Its only after it warms up or gets hot. I would take it to a dealer if I could get it back sooner than 3 weeks. I have had this bike since it was new in "08". It just started this within the last 6 months.

Posted

i had heard sometimes guys that have problems with codes and such, have unhooked the cdi pin connector for 12-24 hours to kind of reset everything. i wonder if that might work? at first it sounded like the coil, but if its still doing it, it sounds like it might be the cdi box itself ... swampcat07 is the go to guy here but i havent seen him on in quite awhile now. ill ask ck1999_400ex when he is on here ... maybe he has some insight

Posted

CHEAP LED SPARK TESTER ON THE PLUG WIRE AND WATCH FOR A MISFIRE. I am taking a guess at this, That ATV IS carbed correct? It has an eletric choke? If so this choke is automatic? Its heats up over a period of time and closes the enrichner circuit. You said it starts cutting out, could it be flooding from the choke not working right? Black smoke? simple ohm test should tell you good or bad on the choke. Describe the cutting out loss of power? spiting sputuring, back firing etc? Just wont take throttle?

Posted

I had a gy6 engine in a Hammerhead buggy had bad electric choke. after 20 mins it ran like crap. study up on it in the manual. 3 months b4 parted out a 2005 ACAT 400 and remebered it had similar choke on the caRB! TRIED TO USE THE acat ck ON THE BUGGY ETC...

  • 1 month later...
Posted

New float and carb rebuild did the trick so far. Plowed some deep snow this morning with no problem.

I had plenty of power after it got warm. I have never had a carb do that to me only when it got hot!

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Mikey69
      Heres my story. Kinda long. I guess I was a late bloomer when it comes to quads. I had never ridden a quad in my life. Rode Dirt Bikes as a kid growing up. Back in Oct of '06 I found a Mustang on craigslist. Took it for a test drive one morning before work. Fast car. 351 Cleveland. I had planned on meeting the guy again after work. For some strange reason thats still to this day beyond me, I stopped in Hillsboro MotoSports on the way home from work. I had 6 Grand on me. There was a left over '05 sitting by the front door. It was on sale for $4999. It was $5499 OTD. I didnt even look at anything else. I knew nothing about quads accept I thought it really looked coool and I had the money in my pocket to buy it. I was sitting on it when the salesman walked up and asked... "Can I help you?" Without hestitation I pulled 60 Ben Franklins outta my front pocket and said "I want this Quad. Load it up in my truck." It was just about dark by the time I drove away from the shop. BTW, I didnt bother to ask my ol lady if I could buy it. LOL. Anyway, I took it by the house and showed her. She was kinda stunned but not mad. We drove over to a friend of mines house and unloaded it. I took it to the field across the street from his house. HOLY CHIT!!!!! I was surprised by the power. I had it for about 2 weeks and took it to Sand Lake. I was there a few hours and rolled it on a banked turn at the top of the bowl right before you get to the one-ways. When it rolled, I flew off and landed on my belly. The quad came bouncing and landed on my back. For a month I couldnt even walk. I was scared of it. I considered trading it for a 250EX. Went back to the shop. The salesman said..."Dude!!! You dont want a 250EX!!! Trust me. Just get used to it" I still wasnt convinced. I put it on craigslist for $4000. Calls were coming in. I had a guy that wanted to come look at it that evening. I decided to take it for one last ride at Browns Camp before I sold it. I was still afraid of it. After about 5 minutes I started feeling comfortable on it again. I decided right then, I loved my Honda 450 and would learn how to ride it instead of selling it. That was late Nov of '06. Work was slow for a Painter in Oregon. My new job everyday? Going to Browns Camp and ridding my Quad. I bought my Girl Friend an '02 Blaster. I rode my 450 for 4-6 hours almost every single day for 3 months. And yes, I know my way around Browns Camp pretty well. LOL. In March I bought her an '06 TRX250EX (Thank God I didnt trade my 450 for one of those) LOL Since then, I have become totally addicted to quads. I love them. Couldnt imagine not owning at least one quad. Luckily I have two. My "07 was $6500 OTD in July of '07. Bought it for my Girlfriend. Traded in her 250 EX. A month later we broke up. So, I wound up with two Honda 450's.
       
    • By AnthonyT
      In search of my first ATV? What are good older 4x4 models?
    • By Ajmboy
      So we are almost a month into winter and I've been so busy working on my house that up until today, I didn't realize that we just haven;t gotten any real snow yet to warrant putting the plow on my grizzly. So that got me thinking, what are the latest plows out there and what ATV plows are the best? I've got 2 snow plows for my grizzly, a quadboss pile driver atv plow set up and a snowsport ATV plow. They are both a bit dated now and I tend to stick with the snowsport due to ease of use and I just like it so much. So if you have a plow on your ATV, please let us know what it is and post a picture with your atv/plow would be awesome. Would also like to know what you like and dislike about it.
      This is back a while when I did a write up on these 2 plows.... in 2009 I got the snowsport and in 2012 I got the quadboss.
       
    • By hfrost112
      whats the best way to seal the bead on a tire
    • By Frank Angerano
      So I decided to pick up a small trailer if I could get one for the right price.  I found this one for a few hundred bucks on Craig’s list.  It is  a galvanized trailer which is exactly what I was looking for. The wood was shot and needed some minor repairs which I could care less about as long as the chassis was good. 
      I striped it down and put a new deck on. I had some vinyl realtree graphics that I had laying around so I added them to the fenders which I think worked out well. Very happy with this little guy.  
      I'm having the iron workers at my jobmake me up a few lightweight side rails that will have a 22 degree bend in them to accommodate the tires that slightly hang over the edge and will incorporate some tie down points as well. 








×
×
  • Create New...