Quantcast
Jump to content

Recommended Posts

Posted

Hello all, I am new here and this is my 1st post so please bear with me. I have a 400 kodiak 1996 model. I have a john deere snow plow for my mower a(4 ft. wide). I had someone tell me that it can be put on my atv but I am not sure how the heck you make it mount up under the frame. They told me they used there same mounting brackets that cam with the plow and went to (farm and home store in our area) and bought the brackets to mount underneath. I do not find these brackets. Anyone out there have any advice on how I can do this or where I can go to get some ideas with out spending an arm and a leg? thx for any and all help!!!

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Gwbarm
      Does anyone have a recommendation of a really Heavy Duty ATV cover. I have bought several and they do keep the water off somewhat, but they are very thin and do not contour with the shape very well and water pools up in the rack louvers. I think i may be looking for a heavy canvas one, if anyone has a recommendation it would be greatly appreciated.
    • By AnthonyT
      In search of my first ATV? What are good older 4x4 models?
    • By Thumpinhard25
      First thanks for any help guys, new to the forums and it's gotten me this far. I bought a 2001 bear tracker 250 for my family to get around the dirt bikes races. It wasn't running right and had a high idle. Previous owner thought it was a carb problem, so he ordered a new Zoom carb and new intake boot, but it still had the same high idle. ( I believe he had the throttle cable adjusted wrong, because it idled fine when I put it back together) So I tore down and cleaned the stock carb, and it started up and idled fine, but needed to have the choke 1/2 out to run.  I swapped to the new zoom carb and had the same issue. Choke half out bike ran ok. I played with the needle and the pilot screw with no change. ( bike did seem to be running rich though, but didn't get better when I tightened pilot screw or raised meddle) I Took it to the races and once I started bouncing around in the cattle fields the quad started cutting out real bad. It would barely run.  Sometimes it would run with choke off, sometimes choke 1/2, sometime choke full. I cleaned carb again, checked float level, and boots, no change still wouldn't run. Then suddenly it started running ok again.  This makes me believe it's an electrical issue rather then carb. I know there's no air leak, it's been checked, both carbs are clean( I've swapped them out a couple times, it starts up immediately and usually idles fine. But then bogs down/ or stutters under throttle. I saw the post on the guy who disconnected his rectifier and reconnected and suddenly it started working again, which lead me to believe it may be electrical and not carb.  So any advice on what I should check? Any way to test the CDI or rectifier?  Once again, I appreciate your help.  
    • By 1998Zuki250
      Looking to see if anyone has any input on ATV Tires? 1998 Suzuki quadrunner LTF250
    • By Gunny
      Hope you enjoy the video ....
       
       
       
      ...
       
       
×
×
  • Create New...