Quantcast
Jump to content

Recommended Posts

Posted

I have a 1994 Yamaha Kodiak 400 4x4 and it turns over but won't start unless you hook a rope to it and pull it then it starts right up every time and runs fine. At first after you pulled it the first time then run it a while it would start back on its own until it cooled down then you had to pull it again. I noticed that it was putting a little black smoke out of the muffler so we cleaned the carb adjusted it and put a new spark plug in it but it still won't start. What could be wrong with it

Posted

Could it be you are running too rich? How's the air filter and try adjusting your mixture screw. Also is the battery good/correct? How's the cranking with the starter? The revolutions may be too slow to get it going so when you pull it in gear it starts up because its faster cranking. Just some ideas.

Sent from my iPhone using Tapatalk 2

Posted

Adjusted valves still don't start I adjusted on the mixture screws still the same the starter seems like it is turning it over good and fast but might not be fast enough we tried spraying starting fluid in it and it still wouldn't start off it

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Tim Keiper
      1st problem, Does anyone know where I can find a stock carb for my Timberwolf, I have tried two different aftermarket carbs and they both suck. The machine runs great until it gets good and warm, then it keeps stalling unless I feather the throttle. it will even stall while I'm trying to go from 1st to reverse or vise versa. I took it to a buddy of mine who is a bike mechanic for years, and he told me try to find a factory carb. When I look online from dealers it says "NOT AVAILABLE" anyone have any suggestions ?
       
      2nd, The small tab on the rear axle for towing is to short for even pulling my small yard trailer, I can't even turn a little bit and hit hits. I tried making an extension which worked great as far as length, but it bends the tab and then the extension drags the ground. I have an idea of what to do to fix it, but wanted to see if anyone else has had this problem and see how you solved it.
    • By AnthonyT
      In search of my first ATV? What are good older 4x4 models?
    • By Frank Angerano
      So I decided to pick up a small trailer if I could get one for the right price.  I found this one for a few hundred bucks on Craig’s list.  It is  a galvanized trailer which is exactly what I was looking for. The wood was shot and needed some minor repairs which I could care less about as long as the chassis was good. 
      I striped it down and put a new deck on. I had some vinyl realtree graphics that I had laying around so I added them to the fenders which I think worked out well. Very happy with this little guy.  
      I'm having the iron workers at my jobmake me up a few lightweight side rails that will have a 22 degree bend in them to accommodate the tires that slightly hang over the edge and will incorporate some tie down points as well. 








    • By ATVNetwork
      As the 2025 ATV Motocross National Championship Series (ATVMX), an AMA National Championship, got underway with back-to-back Florida AMA Pro only events, it was evident that Phoenix Racing Yamaha’s Joel Hetrick picked up where he left off last season.View the full article
    • By Tinkeringreg
      Hi my name is Greg and I just acquired a free 2000 yamaha kodiac 400 4x4 with the ultramatic transmission that does not run. I plan to get it going and use it around my property

×
×
  • Create New...