Quantcast
Jump to content

Recommended Posts

Posted

Check out this link: http://dougmcgee.org/ATV/Resetting%20Belt%20Warning%20Light.txt

Resetting Belt Warning Light

All the Kawasaki Prairies and Suzuki Twin Peaks "same thing" activates the belt warning light at or close to every 100 hours. The only other thing designed to activate the belt warning light is a belt deflection switch located in the drive belt cover. If the belt deflection trips the switch, you must remove the cover, adjust the belt and reset the switch. If the switch has not been tripped and the belt warning light is activated only because the machine has reached a 100 hour mark the following is the reset proceedure to get you going again without the annoying blinking light. If the belt deflection switch was tripped and reset after the belt adjustment you will still follow the below reset proceedure.

Early 03 models

1. Turn the ignition off.

2. Disconnect the Belt Failure Switch at the two-pin connector above the belt (cvt) cover.

3. Disconnect both sets of the five pin connectors located on the right side just below the shifter above the CVT cover. One plug is black and one is gray. The wires are held with a couple wire holders which are easily bent to release them.

4. Connect these five pin connectors to their opposite pairs, (black to gray and gray to black). Don't break them, they are sometime hard to get apart.

5. Turn the ignition switch on and let the belt warning light flash at least 7 seconds or longer then turn the ignition switch back off.

6. Reconnect the connectors back to their proper mates, (black to black and gray to gray).

7. Reconnect the Belt Failure Switch connector, (two-pin connector above above the belt cover.

On late 03, 04 and 05s do the above in this order. 1-3-4-5-2-6-7. I have successfully reset the light without unplugging the belt failure switch at all.

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By gt_jacket
      Hi,  
      I have an 04 bear tracker, with a minor starting quirk. It starts in gear with brake in.  Neutral and Reverse lights work.   
      But when trying to start in neutral, there is no click or attempt to start with the push button. 
      However if i pull up on the shifter (not hard enough to shift into first though) the neutral light goes off and the start button works and it starts fine.
      All gears shift fine with no issues,  has anyone seen this before?  Just wondering if it is a bad sensor or something needs adjusting. 
      Thanks for any help you can provide.
    • By Vlaco
      I want to replace the factory headlights with LED bulbs. Any idea a good one to get?
    • By bigbell
      Does any know what the stock jets are in the twin peaks?
      I bought the bike with a pipe on it and want to go back to stock setup.
       
    • By Ajmboy
      My 2004 Yamaha Grizzly 660 is still going strong but the battery has not been holding a charge. I replaced it a few years back and have been jumping it lately but after sitting for a few days, it drains out. I recently purchased two car batteries from Weize directly because it was a good price for an AGM. I looked on weize for a YTX20HL-BS and its an AGM at $59.99. I believe they have a promo code you can find. Found it cheaper on Amazon and intalled it yesterday.
       

       
      I ended up buying the same one on Amazon which is $49.99 with a $20% coupon bringing it down to $39.99, which is a pretty good price for an ATV AGM battery.

       

      Just a heads up if anyone needs a new ATV/UTV battery going into winter.
      YTX20HL-BS fits a a good amount of models.
      Arctic Cat:
      Arctic Cat Alterra Arctic Cat ATV 450 Arctic Cat Alterra TRV Arctic Cat Alterra CORE Arctic Cat Alterra XC450 BRP (CAN-AM):
      BRP (CAN-AM) Outlander BRP (CAN-AM) Outlander 660 EFI BRP (CAN-AM) Renegade CF Moto:
      CF Moto Cforce 500 Honda:
      Honda TRX680FA Four Trax Rincon Kymco:
      Kymco Maxxer 450 Kymco MXU 450 Kymco MXU 500 Kymco MXU 700 Polaris:
      Polaris Sportsman Polaris Sportsman Touring Polaris Sportsman XP Polaris Sportsman X2 Yamaha:
      Yamaha Kodiak 700 Yamaha Kodiak 700 EPS Yamaha YFM40FB Big Bear Yamaha YFM40FW Kodiak/Automatic Yamaha YFM40FWN Big Bear Yamaha YFM450FA Yamaha YFM45FA Kodiak Yamaha YFM45FG Grizzly Yamaha YFM45FX Wolverine Yamaha YFM45KD KP Kodiak Yamaha YFM600FW FH Grizzly Yamaha YFM660FP FR FH FL Grizzly Yamaha YFM66FA FG Grizzly Yamaha YFM700DE DH PE PFPH PS Grizzly Yamaha YFM700GD GP Grizzly Yamaha YFM7FG Grizzly Yamaha YFV600FW Grizzly Yamaha YMF5FG Yamaha YFM550PE DE DH Grizzly UTVs:
      Arctic Cat Prowler 500 BRP (CAN-AM) Maverick BRP (CAN-AM) Traxter DPS BRP (CAN-AM) Traxter Base BRP (CAN-AM) Traxter STD BRP (CAN-AM) Traxter BRP (CAN-AM) Defender Kawasaki KAF620 Mule 3000 Kawasaki KAF620 Mule 3010 Kawasaki KAF620 Mule 3020 Kawasaki KAF620 Mule 3010 4x4 Kawasaki KAF620 Mule 4010 4x4 (CN) Kawasaki Teryx All Models (CN) Kymco UXV450 Kymco UXV500 Kymco UXV700 Polaris RZR Polaris RZR 4 Polaris RZR S 800 Suzuki 2005 QUV620F
    • By lindzjo
      Does anyone have a service manual for Qlink 700 atv.I cant find anything on one.Please help
×
×
  • Create New...