-
Similar Forum Topics
-
By BuckBilly
I like to ride in wooded and grassy areas. It takes my mind off the everyday routines and helps me deal with my father's cancer. Also gives me a reason to get involved with forums like this one.
-
By Ejwill
Well while I was waiting for new parts for the choke, I decided to adjust the clutch. When I removed the lock nut, I found the guy I bought it from or someone else had stripped the threads on the adjustment rod. I couldn’t get the adjustment rod to turn without putting a pair of channel locks on the screw driver, this was telling me something was wrong. So now the rod pushes in and out and spins freely too freely. So guess I’ll have to take the clutch housing off to see what’s going on and replace the adjustment rod, it’s threads are beyond repair, and there is something going on with the adjustment rod. If there’s another way please let me know. The further I go the worse it gets. Thanks for any help.
-
By Coyote251
View File 2016 Can-Am Outlander 570, 650 & 850 L-Series service manual
service manual - 2016 Can-Am Outlander L-Series
2016 Can-Am Outlander 570, 650 & 850 Standard Series Here is combined the base manual along with all the needed updates and the 2016 supplement manual into one manual
Submitter Coyote251 Submitted 01/03/2025 Category Can-Am BRP ATV
-
By DaveswMN
Pulled my '86 Moto4 out of shed where it sat for 20 years. I knew it smoked. checked it over a little put in gas and it fired right up!!
Drove about 100 yards, ran about half throttle wouldn't idle. Put on somenew parts, jug/piston and rings, carb and valve seals.
'went together ok, tuned it over by hand about 6 revs whick went well. Hit the starter it fired for about 6 revs and quit. tried it again fired once and then th sound of something slipping like maybe chain slipping over spoket.
Took cover off to watch cam sproket, hit starter again, heard same noise and the cam sproket was not turning but jumping a bit. Chain was still tight. You will probably tell me I need to split the lower case but hoping there mightbe something else.
I don't fully understand the chain tightener, the plunger only moves about 1/4 inch, should it move much more than that when off the motor and compressing it by hand?
Thanks for any thoughts.
-
-
By nblain
Sorry, bit of newbie question on Honda TRX520
Can anyone tell me if it is necessary to drain the engine oil to just remove the oil filter cover?
I recently carried out an oil change and when checking afterwards, found oil leaking from around the oil filter cover (was torqued to 10Nm). I am going to get new O rings to be on the safe side, but was wondering how high the oil level in the engine sits relative to the pump filter and do I have to drain the oil?
TIA
Nigel
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.