-
Similar Forum Topics
-
By Coyote251
I'm trying to help a buddy out with his bike (he's not really on the internet or familiar with these forums) and I'll admit that I am not super familiar with the transmission and clutches in these bikes. I owned a Brute a few years ago, but never had an issue like this that I had to troubleshoot.
So basically my buddy bought a group lot of 650's to build one good bike out of. He got it all put together and has it running but when he pushes on the throttle the clutch doesn't engage till the RPM's are quite high and even when its moving it doesn't really speed up, almost seems like its in "limp mode". He's tried 2 different transmissions so I don't think that's the problem.
Is there any adjustment on the clutch engagement? Anything else I can tell him to look at? Let me know if you need anymore information if you think you can help.
-
By carkivey3
i just picked this up. was told ran fine but overheating issues led to replacing head gasket and head. has not ran since. he is not a mechanic but helped someone else who he could not get back to finish job, got aggravated and put up for sale. i was thinking timing issues. i have 110-120psi on all 3 cylinders so i think valves are correct. dont know about distributor yet. however i have no spark. i have no power going to ignition coil. tried to follow white wire but gets lost in wire harness. does anyone have a wiring diagram? can anyone tell me what conditions have to be met before starting. motor turns over so i would think all safeties are met but you never know.
-
By Ejwill
Well while I was waiting for new parts for the choke, I decided to adjust the clutch. When I removed the lock nut, I found the guy I bought it from or someone else had stripped the threads on the adjustment rod. I couldn’t get the adjustment rod to turn without putting a pair of channel locks on the screw driver, this was telling me something was wrong. So now the rod pushes in and out and spins freely too freely. So guess I’ll have to take the clutch housing off to see what’s going on and replace the adjustment rod, it’s threads are beyond repair, and there is something going on with the adjustment rod. If there’s another way please let me know. The further I go the worse it gets. Thanks for any help.
-
-
-
By motox88
Anyone have bad experience with these clutch kits? Looking to get one for an 80s quad that I have.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.