Quantcast
Jump to content

Recommended Posts

Posted

my 2006 bruin 350 ran great, suddenly it developed problem, it starts great, idles great but when you give it a lot of throttle it breaks down, i checked gas cap and it is fine, where should i start

Posted (edited)

hi and thanks for the helpful info, well i opened the air box to check air filter and low and behold it was 1/4 full of horse feed, mice got in through the air intake, will have to put a screen over that. anyway cleaned it all out being careful not to let anything into the carb, then i sprayed carb cleaner while i gave it throttle, all to no avail. it does seam to be the high speed jet, cause it runs fine until i give 3/4 or moire throttle, so i removed the plastic tank cover, what should i do next, i have taken carbs apart before but want to be very careful, cause i cannot afford to screw this up. also it has kn air filter and it could fit a little tighter so i think it may have sucked up some of the grain dust.

Edited by mgp1
Posted

hi, i got my son to help clean out carb, he is real good with carbs , always has been. anyway we took advice offered here by oxidized_black and cheriah, and cheriah said to pay special attention to the main jet, well you could not see light thru the main jet, we cleaned it and wow does the bruin run now:biggrin: also want to give kudos to my son who dropped the bowl off carb without removing anything except gas tank plastic cover

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Tinkeringreg
      Hi my name is Greg and I just acquired a free 2000 yamaha kodiac 400 4x4 with the ultramatic transmission that does not run. I plan to get it going and use it around my property

    • By Kaz
      Troubleshooting a no spark issue, was running OK, maybe a little rich, turned it off, now no spark. I've checked/ohmed out the main key switch, the start/stop switch, neutral switch, brake switch - all good. It will crank the starter, but no spark with the starter or when I try the pull start. I've checked all fuses and diodes. Swapped battery. New plug. New coil. Swapped in a used CDI - no help. Traced, removed, cleaned, reattached all grounds. Removed things like my winch from the circuits to be sure a bad relay or something was dragging it down. When testing voltages, the orange wire going from the CDI to the ignition coil shows no/very low voltage-shouldn't it have 12V on it? Sometimes I get a very weak, intermittent glow on my spark tester, but not enough to fire the plug. I've checked continuity on just about all wires in the harness. Checked/cleaned/lubed w dielectric grease- all connections, redid a few that looked old/dirty. I've checked the stator resistances, all good, but have a stator and rectifier ordered anyway, will arrive Sunday. I verified that the rectifier has a voltage output back to charge the battery while cranking - 10.5-11V, low, but expected while starter is engaged. What else can I check as part of troubleshooting? I have a Haines service manual, but the 1999 350 4x4 seems to be an odd model, there isn't an exact electrical diagram for it, but found one for another year that has all the same number of wires and same color wires, so I've referenced that. Any hints, tips or advice would be appreciated! Thanks!
    • By P_syko
      I’m brand new to 4 wheelers and just bought a 1987 Yamaha Moto 4 350. It has good compression and fuel, but no spark. I’ve looked high and low trying to find how to test all the components of the ignition system, but can’t find anything. This has a new CDI box on it, but I suspect it might be the stator. How do I test the stator on this? Any help would be greatly appreciated! 
    • By Ajmboy
      View File 1986-2006 Kawasaki Bayou 300 service manual
      This service manual is for a 1986-2006 Kawasaki Bayou 300.
      Adding to downloads library.
      Submitter Ajmboy Submitted 05/11/2018 Category Kawasaki ATV  
    • By kaidella
      Bought 4 wheeler for kids. Used to run and soon as it was put in gear it died. I have put new carburater, new plug and battery. The neutral light won't come on. I replaced the solenoid, then the positive battery cable and today put new relay assembly on. Still no neutral light. Not getting any juice and I don't know why.
×
×
  • Create New...