Quantcast
Jump to content

Recommended Posts

  • 4 months later...
Posted

Hi all! I am at my friend's ranch helping repair stuff. I have been working on a 1991 King Quad that has been causing me some headaches. When I found it in the barn it had 7 quarts of oil in it. I was told by the owner that it did that on it's own - and it would fill the crankcase with gasoline.

I have replaced the petcock, rebuilt the fuel pump, replaced the fuel lines, new air filter, spark plug, battery, muffler (was rusted), replaced the oil with the 3.5 qt JASO MA oil, and rode it around for a bit.

It ran good but it wouldn't accelerate as hard as I was hoping for. I finally got the carb rebuild kit, and got that done. The thing RIPPED up and down the driveway. I was excited so I put the back fender/body piece on, then attempted to ride it some more. Next it would idle for a short while then die, then crank and not start - I did this about 5 times, would get it started, then same issue. I checked spark, fuel flow both fine. Then the next day I started it again hoping the issue was resolved- rode it maybe 40 yards and then it started smoking and spewing oil from somewhere over the gas tank - maybe one of those relief hoses?

At this point I've wanted to take some dynamite to it, but it's not mine and I'm trying to help. The quad shows no oil in the sight glass and I'm guessing won't start. I took two weeks away for thanksgiving, and now I'm back and needing some help. I've looked into rebuild kits - maybe the rings are bad or the valve seals - and it doesn't want to start now because I ran it with low oil?

Other issues - When it was running it had 12.5V - What should I test and how? Rectifier..?

Thanks, I'm really hoping for some help! :D

  • 1 year later...
Posted
On 11/23/2011 at 10:46 AM, quad_king_300 said:

fuel tank petcock diagram is broken. and sucking fuel as some as you rev it. check it for a rip or whole. common problem. easy fix is to block the vacuum line. the side fuel pump is good enough.

When I block the vacuum line it will start up for maybe 2 seconds then die 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Memphis
      Not sure if in right place but here goes
      My 300 is lacking power only reaching 30mph and struggling uphill everything else seems ok other that this problem cleaned all fuel new filter pan and all new fuel pump and spark plug full oil change is there anything I am missing
      ps It is auto and does noy seem to want to get in another gear 5200 rpm at 30mph
       
      Regards
    • By AnthonyT
      In search of my first ATV? What are good older 4x4 models?
    • By Rich1028
      I Crashed My Quad
      Well the Way I Ride, some of you knew it was Inevitable.
      Below are Three Videos.
      First one is Slow Motion of How it Happens.
      Second one is Normal Speed, and what happens after the Accident.
      Third one Follows more of what happens after .

      I Was Riding By Myself. I was going through a Mud HOLE Either there was a log or a rock, or A Dip but just as I was almost through it, Machine, Rolled over on my right side, as soon as I contacted the ground, I Heard A SNAP! I got up, flipped the Quad back over. I had the wind knocked out of me.

      5 broken Ribs
      1 Punctured Lung
      1 Broken Collar Bone
      2023 Quad Riding Season is Over for ME!
       
       
       
    • By Mhatayas
      What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker 

    • By P_syko
      I’m brand new to 4 wheelers and just bought a 1987 Yamaha Moto 4 350. It has good compression and fuel, but no spark. I’ve looked high and low trying to find how to test all the components of the ignition system, but can’t find anything. This has a new CDI box on it, but I suspect it might be the stator. How do I test the stator on this? Any help would be greatly appreciated! 
×
×
  • Create New...