Quantcast
Jump to content

Recommended Posts

Posted

i found out warn stoped making the 4 wheel drive to part time 4 wheel kit for the wolverine ,any idea's where else the kit might be available ?, thanks, nybronc

Posted

I did check ebay, I found 1 for sale for 400.00 buy it now price, I'm thinking about it because I found a wolverine I want to buy but I don't want full time 4 wheel, I found a mint one with low hours but the cost of the atv and the warn unit at 400.00 I might be better off looking for a differant model, I have a warrior now that I like which is why I want a wolverine, I could buy a newer one but not sure if I want a automatic, it takes some of the fun out of it. Todd S.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By AnthonyT
      In search of my first ATV? What are good older 4x4 models?
    • By P_syko
      Which is more reliable? Shaft or chain drive? 
    • By TimothyLindblom
      Hi everyone, I’m new here and new to 4 wheelers. Just got a Yamaha bear tracker 250 and joined here to see if I could get some help.
      The motor runs and it drives if it up on jackstands but if you get on and try to ride it, it starts to drive but then quits after a foot or two and dies out and won’t drive. The guy I got it from said he was running and using it shifting through all the gears great and he started it up the next day and it started this.
      He told me he thought it was the U joint on the driveshaft. He said it was probably worn and needed to be replaced.
      I just finished pulling the swing arm and rear end assembly to check out the U joint and there’s no play in it. It’s tight and not nearly enough play to be loose enough to not catch and go.
      Any ideas on what it could actually be?
      Thanks
      Timothy
    • By mga
      2000 Big Bear 4x4 400.  
      do the front and rear drive shafts have to be lubricated? they have boots on them and i was wondering if i had to pull the boots off and grease the "U" joints? These are the ones close to the engine front and rear.
    • By motox88
      Anyone have bad experience with these clutch kits?  Looking to get one for an 80s quad that I have.
×
×
  • Create New...