Quantcast
Jump to content

Recommended Posts

Posted
Here are some using photobucket.

Snow Shoe Rails-to-Trails

100_0467Small.jpg

Abandoned bridge at SSRT

100_0633Small.jpg

Undisclosed location

100_9551Small.jpg

Potential new trail

100_9932Small.jpg

Next three courtesy of Swampcat (Taken at Lost Trails)

One of the few times I get photographed

IMG_069_02Small.jpg

IMG_070_01Small.jpg

IMG_070_03Small.jpg

Mike

Nice pics Mike.. I like the one with the bridge!

Posted

The bridge isn't part of SSRT, but it is part of the abandoned railroad that SSRT uses. Just something I had to check out, I was expecting the bridge to be removed. I was surprised of its condition. Here are a few from Whiskey Springs.

GEDC1784 (Small).JPG

GEDC1787 (Small).JPG

GEDC1816 (Small).JPG

57d77332f1737_GEDC1784(Small).JPG.0cdf3397eb709396bdcf570bb8520024.JPG

57d7733301376_GEDC1787(Small).JPG.bd21886ad16f041e56b904fb3474385b.JPG

57d7733303a84_GEDC1816(Small).JPG.d7bc13134106c103af9df626948562c6.JPG

Posted
I am looking for a set of spacers for the mud tires and then some engine mods.

I might clip the spring in the carb and drill the slide this spring, still thinking about it.

I also want to arrange some things to help me better in the mud pit. I raced a few times this summer and did average.

l_b441274fc1aa40678780766ff06fb5c3.jpg

The second time (above) I had minor carb issues. The 1st run was awsome but the 2nd I think I took a bit of water on. Had a exhaust snorkel made.

The Third (below) was the first time I ran the 29.5s the only problem was the mud pit was more a pond with a hard botton. Should have switched back to the XTRs, my decision killed me. With the new clutching I hope this is a thing of the past.

l_343d8c265f0a441bb5332bad4226fa78.jpg

I love those pics your cat looks awesome!!

Posted
The bridge isn't part of SSRT, but it is part of the abandoned railroad that SSRT uses. Just something I had to check out, I was expecting the bridge to be removed. I was surprised of its condition. Here are a few from Whiskey Springs.

Nice

Posted
BTT - what has everyone been upto? Is there any interest in a East Coast Arctic Cat ride? I know I can get at least 20 AC riders and have some cool places that would host it.

Here is a vid of the latest ride we did with the cats.

-by9qLGUpKs

And then a poker run from this last saturday (With the Teryx)

rKHnD3DGug0

Awesome job on that video!

Posted
The bridge isn't part of SSRT, but it is part of the abandoned railroad that SSRT uses. Just something I had to check out, I was expecting the bridge to be removed. I was surprised of its condition. Here are a few from Whiskey Springs.

I love the size of your new cat. I bet it can really tear up the trails.

  • 9 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By pastorjeep
      Ok guys, I am a glutton for punishment! I picked up this 01 2wd Rancher because the plastics looked good on the marketplace. It has been sitting in the guys back yard for 10 years. The original engine blew and they swapped in an electric shift 4x4 engine. 😒The engine is locked up and was full of water. The wiring is hacked where they tried to get it to run and the rear end needs new swingarm bearings where they left it laying on the ground in the woods for 10 years. Has anyone here ever did the engine swap? First thing is to straighten out the wiring and get the engine free to see if I can get it to crank over. I have swingarm bearings ordered and a new ignition switch. So hopefully I can at least roll it around soon. 🤣





    • By BuckBilly
      Good morning to all !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
      Let's see if we can make this a daily event.
    • By DaveswMN
      Pulled my '86 Moto4 out of shed where it sat for 20 years. I knew it smoked. checked it over a little put in gas and it fired right up!! 
      Drove about 100 yards, ran about half throttle wouldn't idle.  Put on somenew parts, jug/piston and rings, carb and valve seals.
      'went together ok, tuned it over by hand about 6 revs whick went well. Hit the starter it fired for about 6 revs and quit. tried it again fired once and then th sound of something slipping like maybe chain slipping over spoket.
      Took cover off to watch cam sproket, hit starter again, heard same noise and the cam sproket was not turning but jumping a bit. Chain was still tight. You will probably tell me I need to split the lower case but hoping there mightbe something else.
      I don't fully understand the chain tightener, the plunger only moves about 1/4 inch, should it move much more than that when off the motor and compressing it by hand?
      Thanks for any thoughts.
    • By mga
      I just saw a video on TikTok where some guy took the rear end off an ATV and bolted on a roto tiller in place of rear wheels. I wish i saved that video to post here....good thing it was 4 wheel drive...lol but, it seemed to work.
      I'm not sure how he made it bolt on to the drive....
    • By kawasig
      Hello there
      I'm having a problem finding a quality carburetor for a 1993 Suzuki Quad Runner lt-f 250 2x4. I find a lot that have 3-4 star ratings. And all so far don't have the right throttle Cable inlet at the top. The last one I got 4 star on Amazon has a threaded cable sheath rest that could be partially drilled to work. I would prefer to get one I don't have to modify. Any recommendations are greatly appreciated!



×
×
  • Create New...