Quantcast
Jump to content

86 250r

TPbandit

By TPbandit
in ATC 3-Wheeler Forum

 Share

Recommended Posts

TPbandit Contributor

TPbandit

Posted
Posted

Yeah, just purchased a 86 atc 250r off ebay. :biggrin: All original. Got it for $1,325. Think it was a real good purchase. It is in my home town, so there is no travel at all to pick it up. Ill pry toss an extended swing arm on her. Other wise no big plans for mods. It has a new top end with an 1 hour on it. :yes:

TPbandit Contributor

TPbandit

Posted
  • Author
Posted

yeah want to do that in the near future... still wanna find a rolling chasis to make my NIGHT MARES come true.. Just gotta find out what year motor will hold up to my riding.

DirtDemon Veteran

DirtDemon

Posted
Posted
yeah want to do that in the near future... still wanna find a rolling chasis to make my NIGHT MARES come true.. Just gotta find out what year motor will hold up to my riding.

I would recommend the newest one you can find, the different years aren't that much different. The '85-'86 motors have higher compression, especially the '85. In '87 they began using the long rod. Gearing changed a bit over the years also. All in all, the newer the motor the better as a newer motor will likely be in better condition and be easier to find parts for.

TPbandit Contributor

TPbandit

Posted
  • Author
Posted

picked the trike up today. it is in awesome shape. bearings, seals, were all replaced, levers and maier rear fender, and after market grab bar also. Runs on high octane fuel, round 105 believe. He said he was wasting 350 banshee modded out. will try to get pics on here soon. been haven probs. putting pictures on the net.

mywifeknowseverythin Grand Master

mywifeknowseverythin

Posted
Posted

I think he got an 86 250R......From the sound of what you have run for fuel....I dont envy you:no: Almost 7.50 a Gal here and I can Still Spank you on my Pump Gas Trike....LMAO!!!! Just Kidding....Get some pictures up....I want to see what color the motor is....Make sure you got a Correct 86:yes::huh:

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Forum Topics

    • kawasig
      I just bought a rare beast!
      By kawasig
      Hello All
      I'm kinda new to ATVs. I just bought a 1987 Suzuki quad runner 230 Dual Range. I'm having a problem finding info on it. It's very clean, only 2.800 miles. The front wheels are only 30 in.center to center. I was thinking about adding wheel spacers to give it more stability. I realize the added stress on ball joints and bearings. I'm wondering if there are any other concerns? Any input is greatly appreciated!
    • Kaz
      1999 Yamaha Big Bear 350 4x4 no spark
      By Kaz
      Troubleshooting a no spark issue, was running OK, maybe a little rich, turned it off, now no spark. I've checked/ohmed out the main key switch, the start/stop switch, neutral switch, brake switch - all good. It will crank the starter, but no spark with the starter or when I try the pull start. I've checked all fuses and diodes. Swapped battery. New plug. New coil. Swapped in a used CDI - no help. Traced, removed, cleaned, reattached all grounds. Removed things like my winch from the circuits to be sure a bad relay or something was dragging it down. When testing voltages, the orange wire going from the CDI to the ignition coil shows no/very low voltage-shouldn't it have 12V on it? Sometimes I get a very weak, intermittent glow on my spark tester, but not enough to fire the plug. I've checked continuity on just about all wires in the harness. Checked/cleaned/lubed w dielectric grease- all connections, redid a few that looked old/dirty. I've checked the stator resistances, all good, but have a stator and rectifier ordered anyway, will arrive Sunday. I verified that the rectifier has a voltage output back to charge the battery while cranking - 10.5-11V, low, but expected while starter is engaged. What else can I check as part of troubleshooting? I have a Haines service manual, but the 1999 350 4x4 seems to be an odd model, there isn't an exact electrical diagram for it, but found one for another year that has all the same number of wires and same color wires, so I've referenced that. Any hints, tips or advice would be appreciated! Thanks!
    • P_syko
      Hello all!
      By P_syko
      Hello all! I’m new to the 4 wheeler world, but not new to the mechanic world. I was a diesel mechanic for many years and last year got into jet skis. I just bought a 1987 Yamaha moto 4 350 and now learning the ins and outs of 2 stroke engines. Looking forward to learning all the things. 
    • wheeliewayne
      big bear 400 hard shifting
      By wheeliewayne
      my  2012 big bear 400 is hard shifting  can anyone help me
    • DaleJAM
      what year is my Yamaha i just got ?
      By DaleJAM
      so i cant read the vin clearly but i have added some pictures, hopefully someone sees it correctly. took a picture of what it looks like, they painted it Green It is underside a SKY BLUE original. has one spark plug . 3 relays in the back + rectifier. has one relay in the front. has cdi in the front three plugs off it. 
      If you need more info or pictures please ask. 
      the wire harness is trashed i want to rewire it but correctly. 






COMMUNITY SECTIONS

ATV FORUMS

QUADCRAZY MEMBERSHIP

Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?

SIGN UP TODAY

ADVERTISE WITH US

FOLLOW US ON

  • Automotive Webmaster
×
×
  • Create New...