Quantcast
Jump to content

Recommended Posts

Posted

I have a 2007 honda rancher 420 with trans problems. When I am riding it with the motor at around half and throttle and up the gear light will start to flash and then go away for about 5 seconds and then a dash will come up where the gear is sapose to be. I have to cut the fourwheeler off and use the front brake to crank it in gear and than wait a few seconds before it will shift. It does it in all gears except reverse as far as I know. It started about 4 months ago and is getting worse everytime i ride it. Please help me figure out how to fix it or atleast what is going on so I can take it to have it fixed.

Posted

Unfortunately I do not have any parts diagrams for that, you should really invest in a good manual for that machine.

But try looking on the left side if the machine under the fender. Look for electrical wires to a sensor. Maybe wires are sheered or sensor cracked. Do you have a metal cover over by the starter area?

Posted

I know there are sensors under the left fender (looking from the front) I will check them tomorrow when I get off duty thanks for the help i will get back to you.

Posted

There is a sensor that is referred to as the angle sensor, which could be your issue. If you are not confident, you should have someone troubleshoot it for you at a shop/dealer.

Once you locate the sensor, look at the condition of the wires, connector, and sensor iteself. Make sure no trail debris hit it.

420code221cw7.jpg

Look at #10 below:

HJ0706035051.gif

If it turns out bad, go to Bike Bandit where you can get it for @ $70 Part# 5904359-001

  • 4 weeks later...
Posted
There is a series of long & short flashes you have to count ..

I didn't know that..how do you set it to flash/check? Are you putting it into some sort of flash/diagnostic mode?

  • 11 years later...
Posted

I have a 2007 Honda rancher when I drive with a heavy trailer  around it feels like someone is putting on the brakes until I let up off the gas something makes an a mechanical noise on the motor and releases and lets the quad resume for about another 50 feet then starts to slow down and does the same thing drives fine when not towing anything

  • 4 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By BuckBilly
      I like to ride in wooded and grassy areas. It takes my mind off the everyday routines and helps me deal with my father's cancer. Also gives me a reason to get involved with forums like this one.
    • By Trent Finnessey
      I’ve got a 2000 400ex with a dg slip on muffler, it came with he stock muffler on it but the previous owner had the dg in a box so I put it on. I’ve been riding it for the past month and a half and every time I let off it backfires, and the other day the backfires got way louder, 2x louder! I’m concerned that I may hurt my motor? Why does is backfire??? Thanks
    • By Tinkeringreg
      Hi my name is Greg and I just acquired a free 2000 yamaha kodiac 400 4x4 with the ultramatic transmission that does not run. I plan to get it going and use it around my property

    • By Dumass
      My name says it all. I have a '03 Honda Sporttrax 400EX with a new aftermarket carb on it that seems to be having issues. I can start it but it idles really rough and when I give it throttle it just kills the engine. I have tried adjusting the idle screw but to no avail. I am in the San Diego Ca area. 
      Any advice will be greatly appreciated. I would also like to get an owners manual for the thing too but can't seem to find a downloadable one.
    • By Arizona
      I recently bought a 87 TRX 250 not running of course, the owner had a brand new Key Switch on it.
      I think it is the wrong one or wrong wire colors as the colors dont match up with wiring diagram i downloaded for it. 
      anyone have a pic of their ign switch wires where they connect with the wire colors for that model? I ended up leaving the black/w stripe and
      green wire disconnected in order to hot wire it for other testing but would like to know as the colors dont match diagram. 


×
×
  • Create New...