Quantcast
Jump to content

Recommended Posts

Posted

is there a big difference in the shock YFZ450 shock to the elka basic shock that has a rezzy or piggyback whats different about them?

I do alot of motocross the jumps arnt that big, the biggest one i hit is a about 60-70ft. but i bottom out im just wondering if the basic elka reg. travel shock thats triple rate is good enough or should i go with a more advanced elka shock thats triple rate and has a compression adjustment

I have +2 houser reg. travel a-arms

Posted

I think in the long run you would be happier with the more advanced. The more adjustability you have, the more you can dial it in for your needs. They are better than your stock because of the compression rating. Stock will bottom out alot easier.

Posted

i know theres compression, rebound, preload,high/low compression and rebound.

I kno what all the adjustments do, i just wanted to know if the basic elka shock was good enough for me or do i kno a more advanced shock

Posted
i know theres compression, rebound, preload,high/low compression and rebound.

I kno what all the adjustments do, i just wanted to know if the basic elka shock was good enough for me or do i kno a more advanced shock

it wuold be worth it to buy the more advaced, just because if you have to upgrade, you already have an awsomely good shock.

Posted
is there a big difference in the shock YFZ450 shock to the elka basic shock that has a rezzy or piggyback whats different about them?

I do alot of motocross the jumps arnt that big, the biggest one i hit is a about 60-70ft. but i bottom out im just wondering if the basic elka reg. travel shock thats triple rate is good enough or should i go with a more advanced elka shock thats triple rate and has a compression adjustment

I have +2 houser reg. travel a-arms

The stock YFZ shocks are pretty darn good but since you have put wider arms that has probaly softened them up. But are you bottoming in the rear or the front? There is different versions of the YFZ shocks also. Do you have high and low speed compression adjustability or a single compression adjustment? Where is your compression adjustment set at now?

Posted

what year is your YFZ? I run stock 08 shocks on my o5, the 07 BB edition has the better shocks to. The stock shocks can be revalved and resprung(by the right ppl) to compensate for your a-arms and will handle just as good as the elkas, they can even be extended for longer travel.. and that runs around $800 all the way around. but as for elkas, if in doubt and you can afford it, go with the better ones, the what ifs dont hurt as bad..:laugh:

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By kawasig
      Hello All
      I'm kinda new to ATVs. I just bought a 1987 Suzuki quad runner 230 Dual Range. I'm having a problem finding info on it. It's very clean, only 2.800 miles. The front wheels are only 30 in.center to center. I was thinking about adding wheel spacers to give it more stability. I realize the added stress on ball joints and bearings. I'm wondering if there are any other concerns? Any input is greatly appreciated!
    • By Kaz
      Troubleshooting a no spark issue, was running OK, maybe a little rich, turned it off, now no spark. I've checked/ohmed out the main key switch, the start/stop switch, neutral switch, brake switch - all good. It will crank the starter, but no spark with the starter or when I try the pull start. I've checked all fuses and diodes. Swapped battery. New plug. New coil. Swapped in a used CDI - no help. Traced, removed, cleaned, reattached all grounds. Removed things like my winch from the circuits to be sure a bad relay or something was dragging it down. When testing voltages, the orange wire going from the CDI to the ignition coil shows no/very low voltage-shouldn't it have 12V on it? Sometimes I get a very weak, intermittent glow on my spark tester, but not enough to fire the plug. I've checked continuity on just about all wires in the harness. Checked/cleaned/lubed w dielectric grease- all connections, redid a few that looked old/dirty. I've checked the stator resistances, all good, but have a stator and rectifier ordered anyway, will arrive Sunday. I verified that the rectifier has a voltage output back to charge the battery while cranking - 10.5-11V, low, but expected while starter is engaged. What else can I check as part of troubleshooting? I have a Haines service manual, but the 1999 350 4x4 seems to be an odd model, there isn't an exact electrical diagram for it, but found one for another year that has all the same number of wires and same color wires, so I've referenced that. Any hints, tips or advice would be appreciated! Thanks!
    • By DPDISXR4Ti
      I hadn't driven my Kodiak for a two months, and since it was low on fuel, the first thing I did was filled it up to maybe 7/8 full. Getting ready to start it, I rotated the fuel selector switch to "on" and within seconds I smelled and saw fuel dripping onto the floor. I quickly turned it off and the fuel gradually stopped - I can repeat this.
      The fuel is flowing from the hose that is connected to the bottom of the carb, and routes around to the left side toward the wheel well. Any idea what's going on here? It ran fine the last time I had it out.
      Thanks...
    • By wheeliewayne
      my  2012 big bear 400 is hard shifting  can anyone help me
    • By DaleJAM
      so i cant read the vin clearly but i have added some pictures, hopefully someone sees it correctly. took a picture of what it looks like, they painted it Green It is underside a SKY BLUE original. has one spark plug . 3 relays in the back + rectifier. has one relay in the front. has cdi in the front three plugs off it. 
      If you need more info or pictures please ask. 
      the wire harness is trashed i want to rewire it but correctly. 






×
×
  • Create New...