Quantcast
Jump to content

Recommended Posts

Posted

Can get these for Less than $2 each in bulk. Share with friends. Use extra for DIY generators? Any reason why you shouldnt use an overpowered version of smaller units? so far they have worked for me! Automobile Alternator stops charging? you could spend $100s to replace, or wire up 1 of your handy dandy Voltage Regulators! Im not selling, just trading valuable information. 

YOUR TURN! Show your uses! Brag about your Failed installations also! We all learn something

 

rectified.jpg

Posted
21 hours ago, DmanYo said:

I need a wire Diagram. I could keep searching and find for no work. Or ill throw a few Frugal ideas around in exchange.

Just a small problem.  Those bridge rectifiers would not work to rectify and regulate the output  of a quad's stator.  You would need 3 of them  just to rectify the output of the stator.  Then  you need circuity to smooth those voltage pulses from the  3 phases, and a regulator chip to limit that voltage to between 13.2 to 14.6 to actually  charge the battery.  There's a lot more circuitry inside that little rectifier/regulator  box than you  realize.

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By AnthonyT
      In search of my first ATV? What are good older 4x4 models?
    • By Frank Angerano
      So I decided to pick up a small trailer if I could get one for the right price.  I found this one for a few hundred bucks on Craig’s list.  It is  a galvanized trailer which is exactly what I was looking for. The wood was shot and needed some minor repairs which I could care less about as long as the chassis was good. 
      I striped it down and put a new deck on. I had some vinyl realtree graphics that I had laying around so I added them to the fenders which I think worked out well. Very happy with this little guy.  
      I'm having the iron workers at my jobmake me up a few lightweight side rails that will have a 22 degree bend in them to accommodate the tires that slightly hang over the edge and will incorporate some tie down points as well. 








    • By Heymax
      I bought a 2003 Bombardier Quest XT 650
    • By Jhb12686
      Hello I appreciate the welcome into the group. I am beyond frustrated with this desperate search for parts. I have a 2013 XY power sports UTV 300. I had a catastrophic failure in my rear differential which resulted in the destruction of almost everything inside. I have located everything I need to completely redo the rear end. But I cannot find a short side axle shaft with six splines etc. it's an offset differential and one shaft is longer than the other and I need the short one. The tip of it broke off (pic). Any help in getting another shaft for this thing would be GREATLY appreciated. Thanks guys

    • By DmanYo
      Am i tthe only one that likes to spend endless hours building from scratch? Just to be frugal. Or is the addiction actually to obtain knowledge?
×
×
  • Create New...