2016 bad boy onslaught 550cc Looking for parts
-
Similar Forum Topics
-
By pastorjeep
Ok guys, I am a glutton for punishment! I picked up this 01 2wd Rancher because the plastics looked good on the marketplace. It has been sitting in the guys back yard for 10 years. The original engine blew and they swapped in an electric shift 4x4 engine. 😒The engine is locked up and was full of water. The wiring is hacked where they tried to get it to run and the rear end needs new swingarm bearings where they left it laying on the ground in the woods for 10 years. Has anyone here ever did the engine swap? First thing is to straighten out the wiring and get the engine free to see if I can get it to crank over. I have swingarm bearings ordered and a new ignition switch. So hopefully I can at least roll it around soon. 🤣
-
By Coyote251
View File 2016 Can-Am Outlander 570, 650 & 850 L-Series service manual
service manual - 2016 Can-Am Outlander L-Series
2016 Can-Am Outlander 570, 650 & 850 Standard Series Here is combined the base manual along with all the needed updates and the 2016 supplement manual into one manual
Submitter Coyote251 Submitted 01/03/2025 Category Can-Am BRP ATV
-
By flyinbrian365
View File 2016-20 SXS Pioneer 1000 M3-M3P-M3LE-M5P-M5D-M5LE service manual
2016-20 SXS Pioneer 1000 M3-M3P-M3LE-M5P-M5D-M5LE service manual
Submitter flyinbrian365 Submitted 12/15/2024 Category Honda UTV
-
By geezer99
I have an Axis 500 made by Hisun. I uses a solid rear gearbox with no differential action.
I would like to convert this to a true differential with locking ability. I've searched all over trying to find a source with no luck.
Has anyone done this before, or know of a source?
Thanks, Tom
-
-
By DaveswMN
Pulled my '86 Moto4 out of shed where it sat for 20 years. I knew it smoked. checked it over a little put in gas and it fired right up!!
Drove about 100 yards, ran about half throttle wouldn't idle. Put on somenew parts, jug/piston and rings, carb and valve seals.
'went together ok, tuned it over by hand about 6 revs whick went well. Hit the starter it fired for about 6 revs and quit. tried it again fired once and then th sound of something slipping like maybe chain slipping over spoket.
Took cover off to watch cam sproket, hit starter again, heard same noise and the cam sproket was not turning but jumping a bit. Chain was still tight. You will probably tell me I need to split the lower case but hoping there mightbe something else.
I don't fully understand the chain tightener, the plunger only moves about 1/4 inch, should it move much more than that when off the motor and compressing it by hand?
Thanks for any thoughts.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.