Quantcast
Jump to content

Recommended Posts

Posted

2006 rancher 350 Trx350te will not shift with electric shifter or with the manual emergency shifter. Could something in the electric shifter stop the manual shifter from shifting also? Should I start there? Thanks for any help.

Posted

Was the engine running or were you rocking the bike back and forwards, as you tried shifting with the manual shifter ?

They generally won't change gear manually if the engines turned off unless you rock them.

To diagnose what's wrong with the electric shift you need to download the service manual and have a read, and then start following the diagnostic process they lay out. An early check is to see if the dash is flashing at you, and then to read the stored trouble codes which give an indication of which bit isn't operating correctly. Then you check the indicated bit, and it's wiring, and all and any bit's indicated as not operating correctly, before deciding which bit is the cause and which are not operating correctly as a result.

  • Thanks 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Tinkeringreg
      Hi my name is Greg and I just acquired a free 2000 yamaha kodiac 400 4x4 with the ultramatic transmission that does not run. I plan to get it going and use it around my property

    • By Kaz
      Troubleshooting a no spark issue, was running OK, maybe a little rich, turned it off, now no spark. I've checked/ohmed out the main key switch, the start/stop switch, neutral switch, brake switch - all good. It will crank the starter, but no spark with the starter or when I try the pull start. I've checked all fuses and diodes. Swapped battery. New plug. New coil. Swapped in a used CDI - no help. Traced, removed, cleaned, reattached all grounds. Removed things like my winch from the circuits to be sure a bad relay or something was dragging it down. When testing voltages, the orange wire going from the CDI to the ignition coil shows no/very low voltage-shouldn't it have 12V on it? Sometimes I get a very weak, intermittent glow on my spark tester, but not enough to fire the plug. I've checked continuity on just about all wires in the harness. Checked/cleaned/lubed w dielectric grease- all connections, redid a few that looked old/dirty. I've checked the stator resistances, all good, but have a stator and rectifier ordered anyway, will arrive Sunday. I verified that the rectifier has a voltage output back to charge the battery while cranking - 10.5-11V, low, but expected while starter is engaged. What else can I check as part of troubleshooting? I have a Haines service manual, but the 1999 350 4x4 seems to be an odd model, there isn't an exact electrical diagram for it, but found one for another year that has all the same number of wires and same color wires, so I've referenced that. Any hints, tips or advice would be appreciated! Thanks!
    • By leecon
      WANTED MAIN CONTROL BOX/BRAINS for a 2014 Titan UTV Scout E2.
    • By KSIM
      View File CFMOTO C-Force 550 (CF500AU) service manual
      CFMOTO C-Force 550 (CF500AU) service manual
      CF500AU-6L-РУКОВОДСТВО ПО ОБСЛУЖИВАНИЮ-150513.pdf
      Submitter KSIM Submitted 03/19/2025 Category CFMOTO ATV  
    • By KSIM
      View File CFMOTO CF500-6 CF625-3 (CF600-3) CF625-6 (CF600-6) service manual
      CF-MOTO cf625-3 и cf625-6-cf600-6 service manual
      CFMOTO CF500-6  CF625-3 (CF600-3)  CF625-6 (CF600-6) service manual
      Submitter KSIM Submitted 03/19/2025 Category Other Brands UTV  
×
×
  • Create New...