-
Similar Forum Topics
-
By neilroy87
I have a 1990 Bayou 220 that runs pretty well for it's age--needs a new muffler, but sounds tough. Have had to start with a pull cord since I got it, and recently started troubleshooting the start button. Finding a lot of information on this issue in the forum, but haven't been able to chase it down yet. Got a new battery, new starter solenoid, and going to replace the starter relay this week, but not convinced that's going to do the trick, since I can't get the neutral light on when turning the key on. I can start it by jumping the solenoid, but the 2 black wires to the relay do not activate the starter. Bad ground or a short somewhere? Is there a good way to just test the ground?
-
By Sportsman500guy
I bought a 1996 Sportsman 500 4x4 about a month ago, and I love it. Unfortunately, I've been experiencing a few problems with the high-range gear. The first problem is that the gear selector will intermittently pop out of high and into neutral. This problem will sometimes occur when starting from a stop and sometimes will also occur while at cruising speed. The last time this happened I stopped and put it back into gear, however, as soon as I tried to throttle the machine would die. I turned it on again with no problems put it back into high and it died again. Once again I turned it on with no problems put it into low instead and it worked fine with no problem. I drove in low down the road slowly for a little and then shifted back into high with no issues.
I plan on working on it this weekend and would just like some opinions or feedback from anyone who may have experienced these problems before. I'm very mechanically inclined but im unsure of exactly where to start as this is the first Polaris ATV that I've owned. Any feedback is appreciated and thanks in advance
-
By PIYIRIO
Hi all - I recently had a shop fix this quad and it hasn't been right since. The jug was resealed as it was leaking, the rings were replaced, and the valve stem seals replaced. Shop said the cylinder walls were great so nothing was done there. The motor still smokes, heavily on startup and all but quits once warmed up. Enough that I can live with it if I can fix what I came to ask about. I mentioned this work because since I've gotten it back it seems like it has power but tops out at a much slower speed than before. It's old so I don't have a speedo but I pulled out my phone at it tops out at 25 mph. I know before the work, I was getting up to 45+ mph... It's so bad, my 10 year old daughter is pulling away and straight leaving me in the dust with her governed Polaris 90.
Given the work done, what are some thing I could be the cause of such a drastic difference? I immediately thought timing but the marks appear to match up with a youtube video I found... no idea if it's correct though. It sat in another shop for 2 months and they gave me an $800 quote just for the starter... it pull starts fine.
FYI: I would take it back to the original shop to figure out but I had some issues that make them a no-go for me.
-
By Chucksta
So.. It has now become cranky about changing from "drive" to "reverse". Sometimes it's seamless as it's always been, other times it just goes "click, click....click, click " when going from reverse to forward, or from forward to reverse.. Then it gives up and just stops at neutral. Only thing that seems to help is to give it a bit of a bump / wiggle with my own weight. Any ideas as to what to check? It's low miules / hours .. Dealership maintained..
-
-
By Wam12905
Hey all!
I recently acquired an 02 big bear 400 this past summer, carb on it was shot to sh** (pics attached) so my father recommended I just buy a new one off amazon. I purchased the first one that came up as compatible and once it came in, I bolted it in and it fired right up with no noticeable issues. Once I got to the trails with it I realized that on any un-level ground, there's little power output. I checked with 3 different local shops and they all refused to work on tuning up off brand carbs because of how terrible they are. One shop had a motorcycle in with an aftermarket carb and the mechanic said that that would be me if I brought my big bear in. Whoever owned the motorcycle and needed their aftermarket carb tuned up had racked up the bill to nearly $1500. Needless to say he made it clearly obvious that putting any amount of money into an aftermarket carb is not worth it. Now that I've learned all of this, I'm wishing I didn't toss the old carb for a $30 amazon one. In light of this minor f-up does anybody have any recommendations for high quality carbs for my vehicle? I've also attached pictures of the old carb and its condition for your curiosity, although its current condition is likely 6 feet under in a landfill somewhere.
https://www.ebay.com/itm/283488113569?_skw=Big+Bear+400+Carburetor+Oem&epid=10042848409&itmmeta=01JCDWCTMJX5GBC407RF2PPVDD&hash=item42013553a1:g:INUAAOSwn8llquIL&itmprp=enc%3AAQAJAAABAHoV3kP08IDx%2BKZ9MfhVJKkIMhqd%2Fye0vA0YMR5DUzMoCLl0F9GPNRfuAJKaylVqqyVrZCBJVvXQaPrlosjt%2FZnIHyIRPuGiIbxC9o%2B02UqGA4YqXDyyH4bVebnTPz8P5Elg76CvLdu3KyZgwpgpSeYJK2IOWtlo9vtTld7RVjqPwSv1VF26v6kyXGesAB%2BA%2BCHsj3OnqNrHMyKCBuDMSSvUWvOfq%2BKsZKqyHR7yduef%2BHBlXvfiyRJPThHr7Ge9n%2BHBbuxRCb4oF7%2Fp8oZsvajHy9YDitFRfNJeeAssYbgXuhAc7AVvUZZ2YxKW9GzDdxltLMap8orKJtr%2BIk0SRGQ%3D|tkp%3ABFBMsqqzvONk
I found this one on EBAY that advertises as a genuine OEM part for a fraction of the $650 that they're normally worth. Any help would be greatly appreciated, thanks!
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.