Quantcast
Jump to content

Recommended Posts

Posted

So it's been a while since I was on here begging for knowledge but....here I am again, like a bad penny.

So my 300 bayou was fine and I drive it close to 30 miles a day ( no joke, no license). I pulled over to light a cigar and drove 100 ft and started down a dip in the dirt road and it acted like it was out of gas (just filled the tank) but then when I tapped the brakes it started running fine.

Now it'll start but runs rough unless I turn on the headlights and brake light them it'll even out and at first it'll skip and backfire almost them it'll run fine untill it goes to idle them repeat above. If I sh** off the headlights it wants to die. My boss has the same 300 so I swapped battery and cdi and regulator with his and still the same jazz. Could it be the coil? Don't they do like old cars and just die? Also went I throw my voltmeter on the battery while it's running it sits at 9.87-.99 like it's not charging, did that even with different battery, reg., Cdi. Checked the grounds, all good. It's always been a rule that if a battery has only 9 volts then turning on the lights drains power and it runs worse. I'm confused like I just saw a churchmouse kick a barn cats butt

Posted

That's a strange one indeed. Does the battery read the full 12v + with the motor off and just that lower reading  when it is running?   Turning lights or  other accessories on with that low a voltage  should kill it rather than  make it  run better .. I'm  wondering if  maybe there  is a bad diode allowing AC to  cause false readings on your voltmeter.  What  are the readings with  everything turned off , when   ignition on   but nothing running and   is it always that low a reading with the motor running?  Can't help  more than to  just suggest  those checks  to help you diagnose  or someone more knowledgeable than me  to  use to  help  you diagnose it further .

Posted

I would check all your charging system connections first. make sure they are making good connections. With the voltage that low i would say its the stator but it may be that both of them regulators are bad. I had one that past every test i could find to do on it. one test was just barely out of spec and it ran terrible. if you do test on the regulator, follow then exactly. its easy to get that one wrong.

Posted

Regulator is probably bad. I'd replace before it takes out the stator. First use multimeter and verify rectifier is bad and ensure it's not a short to ground. Rectifier should be pushing over 14 to the battery

Posted

Thanks, you were close. I found the white wire that goes to the battery and has the fuse in line had gotten pinched somehow and only had three strands left. Patched it and now everything's fine. Mech from New Zealand gave me the clue when he mentioned turning on the lights to get a few more rpms to a guy who posted about a similar problem with his 400

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Gunny
      Hope you enjoy the video ....
       
       
       
      ...
       
       
    • By BuckBilly
      I like to ride in wooded and grassy areas. It takes my mind off the everyday routines and helps me deal with my father's cancer. Also gives me a reason to get involved with forums like this one.
    • By ATVNetwork
      As the 2025 ATV Motocross National Championship Series (ATVMX), an AMA National Championship, got underway with back-to-back Florida AMA Pro only events, it was evident that Phoenix Racing Yamaha’s Joel Hetrick picked up where he left off last season.View the full article
    • By Kawasakibayounospark
      any one know much about how this system works. Replaced voltage regulator cid box coil pickup coil have power to cid box none out to coil any thoughts. This is cid box number three 
    • By neilroy87
      I have a 1990 Bayou 220 that runs pretty well for it's age--needs a new muffler, but sounds tough.    Have had to start with a pull cord since I got it, and recently started troubleshooting the start button.  Finding a lot of information on this issue in the forum, but haven't been able to chase it down yet.  Got a new battery, new starter solenoid, and going to replace the starter relay this week, but not convinced that's going to do the trick, since I can't get the neutral light on when turning the key on.  I can start it by jumping the solenoid, but the 2 black wires to the relay do not activate the starter.  Bad ground or a short somewhere?  Is there a good way to just test the ground?
×
×
  • Create New...