Quantcast
Jump to content

2013 Polaris Scrambler 850 PTO vs MAG Ignition Wires

JacobSlabach

By JacobSlabach
in General ATV Discussion

 Share

Recommended Posts

Recommended

Posted by JacobSlabach,

ok so did a little digging found that the two cylinders have names (mag and pto) and that the mag cylinder is in the front and the pto cylinder in the back so i needed a mag cylinder ignition wire.  after looking on polaris' parts diagrams i found the specific part number and then on to ebay searched 'polaris scrambler 4014007' and boom there is was for under $20.  so maybe could we get a moderator (@Ajmboy ) to change the title of this forum to something like 'Polaris Scrambler PTO vs MAG ignit

Solution to Issue

Recommended by Ajmboy

  • Like

1 reaction

Go to this post
JacobSlabach Mentor

JacobSlabach

Posted
Posted

Hey so i sold my 04 rubicon and wanted something new so i went to NC and bought a '13 scrambler 850XP LE EPS.  love it the only issues with it when i bought it were a leak in the front tire and the mice had chewed through one of the spark plug wires.  currently have a substitute hooking the chewed end to the ignition coil so itll run on both cylinders however im having an issue finding a replacement coil wire for it and was wondering if yall had any advice.  i need the longer of the two coil wires and i can only find the shorter one online.  will throw up some pics of it when i can

MarkinAR Experienced

MarkinAR

Posted
Posted

About any coil wire should work that is long enough.  Usually you can unscrew the plug boot and unscrew the wire from the coil and replace it.  I've used skinny auto plug wires before.  Anything that will fit into the plug boot and has a good thick silicone shield.

  • Like 1
  • Featured Comment
JacobSlabach Mentor

JacobSlabach

Posted
  • Author
  • Featured Comment
Posted

ok so did a little digging found that the two cylinders have names (mag and pto) and that the mag cylinder is in the front and the pto cylinder in the back so i needed a mag cylinder ignition wire.  after looking on polaris' parts diagrams i found the specific part number and then on to ebay searched 'polaris scrambler 4014007' and boom there is was for under $20.  so maybe could we get a moderator (@Ajmboy ) to change the title of this forum to something like 'Polaris Scrambler PTO vs MAG ignition wires' or something? i think that would help out other ignorant folks like me and save them some trouble if theyre searching on the web for a similar issue.

To wrap it up on a parallel twin atv like a scrambler or sportsman 850 or 1k, the PTO cylinder is in the rear and the MAG cylinder is in the front.

could never find it written that plainly lol had to hinda guess and do a lot of digging

  • Like 1
MarkinAR Experienced

MarkinAR

Posted
Posted

good investigative work!  I use Babbitt's or Partzilla to find the part number of what i need and then search ebay, amazon, etc and usually find it quite a bit cheaper than dealer.  Just have to dig through the diagrams and find what you need.

  • Ajmboy changed the title to 2013 Polaris Scrambler 850 PTO vs MAG Ignition Wires

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Forum Topics

    • Gwbarm
      Trail Tire Valve Replacement
      By Gwbarm
      Have you ever been on the trail and your tire valve goes bad. No way to break down the wheel and replace it. A lot of you probably know about this already i had heard of it but never used one. Just punch out the old one insert and tighten down the nut
       

       

       

       
      So far it has worked very well.
    • hfrost112
      how to get your tire to seal the bead
      By hfrost112
      whats the best way to seal the bead on a tire
    • kawasig
      I just bought a rare beast!
      By kawasig
      Hello All
      I'm kinda new to ATVs. I just bought a 1987 Suzuki quad runner 230 Dual Range. I'm having a problem finding info on it. It's very clean, only 2.800 miles. The front wheels are only 30 in.center to center. I was thinking about adding wheel spacers to give it more stability. I realize the added stress on ball joints and bearings. I'm wondering if there are any other concerns? Any input is greatly appreciated!
    • Kaz
      1999 Yamaha Big Bear 350 4x4 no spark
      By Kaz
      Troubleshooting a no spark issue, was running OK, maybe a little rich, turned it off, now no spark. I've checked/ohmed out the main key switch, the start/stop switch, neutral switch, brake switch - all good. It will crank the starter, but no spark with the starter or when I try the pull start. I've checked all fuses and diodes. Swapped battery. New plug. New coil. Swapped in a used CDI - no help. Traced, removed, cleaned, reattached all grounds. Removed things like my winch from the circuits to be sure a bad relay or something was dragging it down. When testing voltages, the orange wire going from the CDI to the ignition coil shows no/very low voltage-shouldn't it have 12V on it? Sometimes I get a very weak, intermittent glow on my spark tester, but not enough to fire the plug. I've checked continuity on just about all wires in the harness. Checked/cleaned/lubed w dielectric grease- all connections, redid a few that looked old/dirty. I've checked the stator resistances, all good, but have a stator and rectifier ordered anyway, will arrive Sunday. I verified that the rectifier has a voltage output back to charge the battery while cranking - 10.5-11V, low, but expected while starter is engaged. What else can I check as part of troubleshooting? I have a Haines service manual, but the 1999 350 4x4 seems to be an odd model, there isn't an exact electrical diagram for it, but found one for another year that has all the same number of wires and same color wires, so I've referenced that. Any hints, tips or advice would be appreciated! Thanks!
    • Mhatayas
      Oil leak 1985 suzuki 250
      By Mhatayas
      What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker 

COMMUNITY SECTIONS

ATV FORUMS

QUADCRAZY MEMBERSHIP

Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?

SIGN UP TODAY

ADVERTISE WITH US

FOLLOW US ON

  • Automotive Webmaster
×
×
  • Create New...