-
Similar Forum Topics
-
By Mhatayas
What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker
-
By P_syko
I’m brand new to 4 wheelers and just bought a 1987 Yamaha Moto 4 350. It has good compression and fuel, but no spark. I’ve looked high and low trying to find how to test all the components of the ignition system, but can’t find anything. This has a new CDI box on it, but I suspect it might be the stator. How do I test the stator on this? Any help would be greatly appreciated!
-
By carkivey3
i just picked this up. was told ran fine but overheating issues led to replacing head gasket and head. has not ran since. he is not a mechanic but helped someone else who he could not get back to finish job, got aggravated and put up for sale. i was thinking timing issues. i have 110-120psi on all 3 cylinders so i think valves are correct. dont know about distributor yet. however i have no spark. i have no power going to ignition coil. tried to follow white wire but gets lost in wire harness. does anyone have a wiring diagram? can anyone tell me what conditions have to be met before starting. motor turns over so i would think all safeties are met but you never know.
-
By EasyE
I have just recently gotten a yamaha big bear 350 atv and I think the carburetor is a little off on its setting,bc it cuts out at full throttle and it makes a weird pluff kinda sound 3-4 seconds after I hit the kill switch to shut the atv off. I don't know why it's doing that so any help will be greatly appreciated.
-
-
By Ejwill
Well while I was waiting for new parts for the choke, I decided to adjust the clutch. When I removed the lock nut, I found the guy I bought it from or someone else had stripped the threads on the adjustment rod. I couldn’t get the adjustment rod to turn without putting a pair of channel locks on the screw driver, this was telling me something was wrong. So now the rod pushes in and out and spins freely too freely. So guess I’ll have to take the clutch housing off to see what’s going on and replace the adjustment rod, it’s threads are beyond repair, and there is something going on with the adjustment rod. If there’s another way please let me know. The further I go the worse it gets. Thanks for any help.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.