Quantcast
Jump to content

Recommended Posts

Posted

thank you the wheeler belongs to my daughter ans it has been stored for a while .  i down loaded both service manual and owners manual . they are very helpful but they dont show one thing over by the start buttom abd light switch there are two yellow buttons  s

one for up one for down .is this for shifting the trans . i dont have a clue . and i cant seem to get the nuteral light  no matter how much i move the shift peddle . thanks for your time in helping an old man 

Posted (edited)

Neutral  light could be  burned out .. Mine is .  The  yellow  buttons   up  and down  may be  for headlights.  They  have nothing to  do with  shifting gears.

Neutral  light  is a convenience  since  it does let you  know  when you  are in neutral, but  if it  doesn't  light  and your quad  won't start in gear  then  the  safety  switch is  working  and either  the  light is burned out  or the   it doesn't get the signal to  light from the switch.  I  don't worry  about the light out on my  quad.

 

Edited by davefrombc
Posted

The starter will  not  run if it is  in  gear.  It  it is  not running   when  you are certain  it is in  neutral it becomes a chore of tracing out the circuit  to  see  where  the fault is.. It  could be a dead battery, broken  wire,  bad ground, a faulty switch  or relay,  or the starter itself. To  be  sure the starter itself is  ok,  you  could  run 12v  directly to  it  with a  jumper cable to see if it spins over.

 

Posted

i think it is stuck in gear jumt across the terminals on the solinoid and the starter engages . . still havent figured out the yellow buttons are the hi /lo for the lights is ion the switch to turn them on

Posted

my ole big red  has a separate dimmer switch but  i got this kawasaki stripper down and that wire off those yellow buttons go to a separate computer board that shifts the trans its weird and it dont show in the serv manual. gonna have to jack it up in back jump it to start and go from there. thanks for your help and time

  • 8 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By P_syko
      I’m brand new to 4 wheelers and just bought a 1987 Yamaha Moto 4 350. It has good compression and fuel, but no spark. I’ve looked high and low trying to find how to test all the components of the ignition system, but can’t find anything. This has a new CDI box on it, but I suspect it might be the stator. How do I test the stator on this? Any help would be greatly appreciated! 
    • By carkivey3
      i just picked this up. was told ran fine but overheating issues led to replacing head gasket and head. has not ran since. he is not a mechanic but helped someone else who he could not get back to finish job, got aggravated and put up for sale. i was thinking timing issues. i have 110-120psi on all 3 cylinders so i think valves are correct. dont know about distributor yet. however i have no spark. i have no power going to ignition coil. tried to follow white wire but gets lost in wire harness. does anyone have a wiring diagram? can anyone tell me what conditions have to be met before starting. motor turns over so i would think all safeties are met but you never know.
    • By EasyE
      I have just recently gotten a yamaha big bear 350 atv and I think the carburetor is a little off on its setting,bc it cuts out at full throttle and it makes a weird pluff kinda sound 3-4 seconds after I hit the kill switch to shut the atv off. I don't know why it's doing that so any help will be greatly appreciated.
    • By hfrost112
      need service manual 1987 suzuki lt230e
    • By Michael76
      Just got a bayou 300 and put a new spark plug in it but it won't start.
×
×
  • Create New...