Quantcast
Jump to content

Recommended Posts

Posted

Here is a great article:

Winterizing Your ATV

By Doug Morris

If you take some steps before putting your ATV away for the winter it will be a lot easier to start it up and get riding later.

First, do some major cleaning, top to bottom. That means every little nook and cranny. You're going to need a good cleaner, scrub brushes and a lot of elbow grease, but it will be worth it.

Make sure you wash underneath also. Turn off the gas, set the parking brake and have a friend help you stand the ATV up. It should support itself on the rear grab bar or rack.

Once you're done cleaning your machine, dry it off and spray everything down with WD40 or equivalent. This will displace those little drops of water that are hiding and will prevent rust from forming.

Second, grab a pen and paper and carefully inspect your entire machine, writing down things that you need to fix or replace. Make a list of what you need to do and keep it with the ATV.

Make sure the lights are working, and all the wiring, levers, cables, etc. on the machine are in good shape.

If you have a 4x4, carefully inspect the rubber CV boots for any cracks or tears. If you find anything suspicious, replace the boots. Water trapped inside will cause you big heartache later.

Also, make sure you check the front and rear differentials. Are they full? What color is the oil? If the oil looks like chocolate milk that means it's contaminated with water and you should change it immediately. Change your engine oil and filter as well.

If your ATV has a drive chain, check to see whether the sprocket teeth are showing wear. If so, order a new chain and sprocket set now—don't just change the chain. But if everything looks good you can just give the chain a good lube job.

Pay special attention to where two sections are welded together when you inspect the frame, A-arms and swingarm. If you see any little rusty lines, then you should take it to a welder before the cracks get worse or break while you are riding.

Finally, with your ATV off the ground on jack stands or a hydraulic ATV jack, grab each front wheel at the top and bottom and check to see that wheel and A-arm bearings aren't wobbling around. Do the same with the rear wheels, checking the swingarm and axle bearings.

Third, take care of your fuel or you'll be sorry later with gummed up carbs. One way to handle this is to add a fuel stabilizer, following the instructions. Another option is to turn the gas off and run your ATV until it starts to sputter, and then engage the choke to burn the last bits of remaining fuel. Don't do that in an enclosed garage!

Fourth, you'll also need to pay attention to your electrical stuff before you put your ATV away for the winter.

Find your battery, which is normally under the seat. Clean the battery terminals and connect a trickle charger. If you let the battery go dead from not being used, it could die for good and you'll have to buy another battery. In inexpensive charger will keep your battery working longer, and your ATV will start in the spring.

Doug Morris is director of the All-Terrain Vehicle Association and has a lot of experience prepping his ATVs for long, cold winters in Colorado and Ohio.

Posted

Step One

Wash your ATV. Scrub every inch. Use an old toothbrush to reach tight areas. Mud and oil can eat away at surfaces over time. Good ATV maintenance involves thoroughly cleaning your ATV before storing it for the winter. As an added protection, hand wax your ATV once it's dry.

Step Two

Change the oil and filters. This keeps excess dirt from settling in your engine.

Step Three

Put gas stabilizer into the fuel tank and top the tank off with fresh gas. For best results, use premium gasoline. Run the ATV for a few minutes to allow the stabilizer to work through the carburetor. Shut off the motor and turn off the gas valve. Oil the chain.

Step Four

Disconnect and pull out the battery. Charge it if necessary, and clean the terminals. Store the battery in a location where it cannot freeze. A heated breezeway is preferable to a cold garage. It's important to keep the battery stored out of the reach of children. battery acid is dangerously corrosive. Store your ATV's battery on a high shelf or locked in a cabinet. Do not store it directly on concrete. Concrete causes power drain in batteries.

Step Five

Push the ATV into a shed or garage. Do not store ATV's outside in winter climates. Place the ATV up on blocks and fill the tires to the correct psi to keep them from weather cracking. Expensive jack stands aren't necessary; cinder blocks or heavy plastic milk crates work just fine.

Step Six

Cap the exhaust. To a mouse, it looks like a fine winter hidey hole.

Step Seven

Tarp the ATV to keep excess dust and vermin away. If desired, leave an open can of auto wax on the floor under the tarp. The smell repels mice, chipmunks and other small pests.

How to Winterize an ATV | eHow.com

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Rich1028
      I Crashed My Quad
      Well the Way I Ride, some of you knew it was Inevitable.
      Below are Three Videos.
      First one is Slow Motion of How it Happens.
      Second one is Normal Speed, and what happens after the Accident.
      Third one Follows more of what happens after .

      I Was Riding By Myself. I was going through a Mud HOLE Either there was a log or a rock, or A Dip but just as I was almost through it, Machine, Rolled over on my right side, as soon as I contacted the ground, I Heard A SNAP! I got up, flipped the Quad back over. I had the wind knocked out of me.

      5 broken Ribs
      1 Punctured Lung
      1 Broken Collar Bone
      2023 Quad Riding Season is Over for ME!
       
       
       
    • By Ethan7387
      Hi could someone please help me, not to sure what engine this is 


    • By qcm413
      Hi,
       
      i need to replace my tire on my atv and i want to know if somebody have a good tire experience on mid-mud terrain and winter plowing. im not sure if i am to go with a tile like a tractor thread or the other ones like ITP mud lite
      thank in advance 
    • By mmikesell
      First post here need some help/advice. I bought a 2001 king quad 300, vin number JSAAK43A212111871. I have been trying to do some basic maintenance as it runs but doesn't idle all that well . I want to take out and clean/repair the  carb but when looking for parts it ask for model X Y K1 K2. How do I know which model I have? I have tried some vin decoders but they haven't told me. If anyone could recommend a carb rebuild kit for my quad Id appreciate it. Also any tips on tracking down an owners manual? 
    • By Andyjack
      Hi quad is up and running now, starts fine, revs and ticks over fine but when riding its bogging a bit. If your sat with engine running its fine but when you set off your having to rev it very slowly to go otherwise it drops its revs. And i mean very slowly, try rev normally and revs just drop off then when your going its bogging slightly. I have tried adjusting air screw but doesn't seem to make a difference. Any ideas. Seems like an air problem but not sure.
×
×
  • Create New...